Thingiverse
Shorter Spearhead For Broom
door Harryapptown
3
Downloads
9
Likes
0
Makes
I had downloaded the 'Spearhead for broom handle (Turn broom into spear)' (thing:5435525), and when I went to print it, It was too tall and I had also noticed a hollow inside.
So I cut that section out, and slightly shortened the blade, to get the height more reasonably sized.
This one seems a lot more stout, and you won't need to cut it into 2 parts and glue them together. (that's where it had broken on my first few attempts)
Did 2 walls and 15% cubic infill. Used Tree Supports for the screw in section, gave the supports a slight wiggle and it unscrewed right out. I would use an outer brim too.
Printed Great on a Bambu A1. Used half accelerations and half speeds, as it could tip easily.
Chopped/cut/merged with Bambu Studios.
For goodness sakes, be safe!
*I AM NOT RESPONSIBLE FOR ANY LIABILITIES, USE/PRINT AT YOUR OWN RISK*
So I cut that section out, and slightly shortened the blade, to get the height more reasonably sized.
This one seems a lot more stout, and you won't need to cut it into 2 parts and glue them together. (that's where it had broken on my first few attempts)
Did 2 walls and 15% cubic infill. Used Tree Supports for the screw in section, gave the supports a slight wiggle and it unscrewed right out. I would use an outer brim too.
Printed Great on a Bambu A1. Used half accelerations and half speeds, as it could tip easily.
Chopped/cut/merged with Bambu Studios.
For goodness sakes, be safe!
*I AM NOT RESPONSIBLE FOR ANY LIABILITIES, USE/PRINT AT YOUR OWN RISK*
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
