Shotgun camera/ flashlight holder

Everything will fit, but fittings are tight.
You also need to buy:

M5 Allenbolt 45mm
M4 Allenbolt 16mm x2
M5 Allenbolt 20mm x2

Bracket is 34mm, usually cameras that i measured were somewhat 35mm. So i made this teenyweeny off, but again, like a tight fit.
I made a few tests with 35mm hole, but that would have required to use some rubber inside the ring to feel secure.
Also, this way, this is 100% printable (well, bolts and nuts are needed to buy).
Also, flashlights that i measured, were 25mm, so there is an adaptor for 25mm included.