Shower drain lint filter holder

This model replaces the stock hair trap from one of those long simplistic shower drains with a larger disposable one which uses washing machine dryer lint filters. I printed this in the orientation which the model is already in using paint on supports where needed. THIS ONLY REPLACES HAIR TRAPS WHERE THE LIP IS AROUND 47mm IN DIAMETER. I printed this in PLA which shouldn't cause issues although it might feel like one at first because pla softens at around 140°F and a water heater should never be set to higher than 120°F. This in addition with the water cooling down by flying through the air makes me confident that the warm water wont be an issue.This uses regular lint filters normally used on the washing machine drain which you can buy at the hardware store or on amazon. Tinkercad: https://www.tinkercad.com/things/0qhdMDOkOqr-shower-drain-filter-upgrade/