Thingiverse
Shower Pan
von markh21518
1
Downloads
0
Likes
0
Makes
This is a Shower Pan interface I designed to tie in the Shower pan to the wall section below for a Truck Camper I built from scratch.
Printing:
Print with a Draft shield from CURA in the experimental section, if using ABS, or an enclosure. Will print 32 mm high, 13 mm wide at base and 250mm long.
Don't print in PLA for a Shower, PLA will dissolve, ABS works well and you can use ABS glue to the shower pan .
Printing:
Print with a Draft shield from CURA in the experimental section, if using ABS, or an enclosure. Will print 32 mm high, 13 mm wide at base and 250mm long.
Don't print in PLA for a Shower, PLA will dissolve, ABS works well and you can use ABS glue to the shower pan .
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!