Thingiverse
Shower Tray
von letscho2k
23
Downloads
12
Likes
0
Makes
This is a shower-caddy to stick onto your shower corners:
Sadly I had to realize not all corners are at a perfect 90 degree angle as they should be... So I alternated between 94 and 86 degrees at two degree increments - that should cover most imperfections.
You will need:
To measure or guess which part you will have to print (40% worked well)
Something to stick it onto your walls
I used my last bits of thick double sided tape and it works better than anticipated but it will remain the bottleneck with this design.
If you need a different size, just post it in the comments.
Sadly I had to realize not all corners are at a perfect 90 degree angle as they should be... So I alternated between 94 and 86 degrees at two degree increments - that should cover most imperfections.
You will need:
To measure or guess which part you will have to print (40% worked well)
Something to stick it onto your walls
I used my last bits of thick double sided tape and it works better than anticipated but it will remain the bottleneck with this design.
If you need a different size, just post it in the comments.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
