Thingiverse
SHOWERHEAD - LOW PRESSURE
por skipgoebel
0
Descargas
2
Likes
0
Makes
we have gravity fed water pressure (8 pounds)
no problem and this head has large holes which means no misting and low evaporation.
Simply put- the water is way hotter so you will definitely save a lot of energy.
Set up for 1/2 inch pipe and you may have to expand holes 10% in your slicer if it is too tight or use a lot of Teflon tape if too loose.
It should be in PETG however I have one also in PLA and its almost 2 years old.
If you love extra hot showers, give this a try.
no problem and this head has large holes which means no misting and low evaporation.
Simply put- the water is way hotter so you will definitely save a lot of energy.
Set up for 1/2 inch pipe and you may have to expand holes 10% in your slicer if it is too tight or use a lot of Teflon tape if too loose.
It should be in PETG however I have one also in PLA and its almost 2 years old.
If you love extra hot showers, give this a try.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
