Thingiverse
Showerhead pivot joint partial replacement
von watsdesign
0
Downloads
0
Likes
0
Makes
Small 3D printed victory of the day.
I partially replaced the original part in order to repair the function to pivot the showerhead. In this case the 3D printed part goes on a cylinder of an existing part that move up/down, so I didn't had to design the clamping part :)
I partially replaced the original part in order to repair the function to pivot the showerhead. In this case the 3D printed part goes on a cylinder of an existing part that move up/down, so I didn't had to design the clamping part :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
