Thingiverse
Shrek Resculpt (35mb)
von Geoffro
472
Downloads
413
Likes
12
Makes
Another beer I owe the talented Adam Beamish and MustangDave!
I wanted to print one of these out for the kids large, so I put the ogre under the clay knife for an hour and gave him a makeover, I also added a base because just looking at it I knew it was going to fall over all the time, the base is small and light to print but should hold the big guy up. I permanently attached the base but you can snap it off easily if you don want it.
Mines printing out now, will post pics in 4.5 hours :)
I wanted to print one of these out for the kids large, so I put the ogre under the clay knife for an hour and gave him a makeover, I also added a base because just looking at it I knew it was going to fall over all the time, the base is small and light to print but should hold the big guy up. I permanently attached the base but you can snap it off easily if you don want it.
Mines printing out now, will post pics in 4.5 hours :)
Geoffro veröffentlicht auch auf
94 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
