Thingiverse
Side marker Miata logo
von Shawn_C
15
Downloads
13
Likes
0
Makes
Someone on Facebook was looking for a lamp cover with logo. I whipped this up in a few minutes. I have not printed it yet. I set it at 1mm thick.
This is for the front. Not sure about fitment on the rear. I imagine they are the same.
"a's" connected.
Uploaed V3. I cleaned up the stl and made it 2.5mm thick,
This is for the front. Not sure about fitment on the rear. I imagine they are the same.
"a's" connected.
Uploaed V3. I cleaned up the stl and made it 2.5mm thick,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!