Side Spool Holder for Bambu Lab P1S

This Side Spool Holder goes more to the front of the printer than most.It gives free access to the belt tensioner on the back of the printer.The Side Spool Holder can probably also be used for the X1C without problems.PrintingNo supports needed.After printing the Spool Holder please remove the anti warp oval.I printed with PLA+, 0.2 mm layer height.Weight 0.14 kg.AssemblyTo attach the Spool Holder to the back of the printer you need four M3 x 6 mm screws.The PTFE Guide slides in the back of the Spool Holder and can be secured by a small self tapping screw. 25 cm of PTFE tube is used between the PTFE Guide and the PTFE Connector. The tubes just slide into the guide and connector.Finally two 608Z roller bearings are needed for the Roller.To make a more strong and stable bond between the Spool Holder and the printer you can use 20 mm wide double sided tape (screenshot).P.S. While waiting for the delivery of the roller bearings the Spool Holder can be used without the Roller.