MakerWorld
3D Printer Accessories
Zum Modell
Side spool holder (NO SCREW)
42
Downloads
12
Likes
22
Makes
This is my idea of a universal side spool holder that can be installed both on left or right side of the printer. Need 2 bearing #608 to make the spool roll.Design to fit every standart carboard roll without any problem.Can fit spool up to 70mm wide. Print both with support, roller up side and holder on the side for maximum strenght,Install bearing on roller and slide it inside the holder.For maximum holding on the side of the printer, i used command strip to stop it from falling when removing the spool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
