Sidewinder X1 cable guide hotbed

- see below for german version

For me the cable management of the Artillery Sidewinder X1 is too unsafe, also I wanted to ground my aluminium based heatbed.

Therefore I created my own strain relief. I bought a textile sleeve with a diameter of 13mm ( https://www.amazon.de/dp/B07FW3GTXB/ ) and a nylon string with a diameter 3mm (e.g. https://www.amazon.de/dp/B074QPS1Y7/ ,but any sort of 3mm Nylon filament will be fine for this purpose). The tension introduced by the nylon inlay will guide the cables to stay rounded.

I used this cable holder https://www.thingiverse.com/thing:4126411 but needed to adjust it as my distance between the edge of the heatbead and the cable was different, 75mm in my case. Also I added a small hole to put the nylon string into it. If you use a different cable holder drilling a small hole might also do the job.

I use this cable gland https://www.thingiverse.com/thing:2937494 mit od=13 and id=10.

Assembly:
Hotbed: Put the nylon string into the h