Thingiverse
Sidewinder X1 Wobble wings
10
Downloads
2
Likes
0
Makes
You will need 20 neodymium magnets with dimensions of 8x3mm and 6-6mm bearing balls. Make sure to install the magnets so that they all attract one another.
Push the three magnets in all the way for each ball bearings. You can adjust the two wing-magnets by pushing out them out so that the magnets are a minimum distance apart to get the greatest amount of attraction force when the two halves go together. Be careful putting them together! There is a lot of attraction forces. Please wear safety glasses when putting them together.
I've been testing these out for the past 7 months and they are a big improvement over the original design. If your printer is dialed in, the magnets should be a snug fit.
Push the three magnets in all the way for each ball bearings. You can adjust the two wing-magnets by pushing out them out so that the magnets are a minimum distance apart to get the greatest amount of attraction force when the two halves go together. Be careful putting them together! There is a lot of attraction forces. Please wear safety glasses when putting them together.
I've been testing these out for the past 7 months and they are a big improvement over the original design. If your printer is dialed in, the magnets should be a snug fit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
