Sidewinder X2 BLTouch

This bracket is for attaching a original BLTouch to the Sidewinder X2.
Its screwed directly to the mounting-points of the Artillery ABL. The blue housing must be cut out accordingly.

The mounting holes are prepared for ruthex M3 inserts. You need short M3 screws for that.

My offset-settings for Klipper:
x_offset:29.4
y_offset:-27.4
z_offset:2.67

Wiring (BLTouch -> SW X2):
black + brown -> GND (you have to crimp it to one pin together)
yellow -> Servo
white -> Probe
red -> +5v

Some information about setting the new offset with the stock firmware (kudos to gonzaloherrera11 in the comments!)
The probe offset will have to be changed but this can be done using Prontaface and simple command lines.
M851 X28 Y-33
then type M500 to save it to eeprom.
then M501 use active parameters
That will be the new BL touch probe positions flashed into eeprom. No firmware updates required.
Ensure that you have CH340 drivers working on your computer