SigmaX Dial Gauge

__Edit 2021-07-10__: Clip to side-mount the gauge as front mount cannot reach the back screw.

__Edit 2021-07-04__: If you d not have the original BCN3d PTFE, it may be to short as you need a 1050mm at least. I cannot find longer then 1M PTFE, thus I designed a coupler to lengthen it - the tension on the head is significant according to the dial gauge.
https://www.thingiverse.com/thing:4900346

__Edit 2021-07-03__: ExtruderClipV2 Added 'fins' to the bottom of the extruder clip for better grip. Increased thread-hole size by 0.4mm


Bracket for a SigmaX extruder for manual bed leveling.
Uses an 8mm shaft dial gauge (digital).

Requires 4 x M4 10mm hex bolts.
Prints without support - teardrop 'tail' on holes should face up if positioned correctly.

The extruder clip does not stay in place good enough - may need to rework it.

When leveling - do the following until it is level.
The first pass will always fail as adjusting the front moves the back up/down.
Clean nozzle - o