Silly's Improved Rambase (+ a 17/32 brass version)

WARNING: THIS DESIGN REQUIRES SLIGHT TRIMMING OF THE PRIMING BARS TO EQUAL LENGTHS. Slug's hardware kits don't have a measured edge from the Rambase hole to the end of the bar, since that usually doesn't matter with a normal Rambase. The priming bars should be trimmed until they fit snug along the bottom edge of the Rambase cutouts when screwed in. Trimming can be done with a file, tin-snips, whatever. A clean cut is nicer looking, but not mechanically needed. WARNING OVER This is my version of an improved Rambase for the Caliburn family of blasters. This Rambase is modified from the Caliburn's Rambase. List of changes: Tighter fit around the Ramrod, so it is a very tight press fit. Use a clamp or vice to put it on, and remove it by cutting off the print, destroying it. (The tight fit means you don't need screws for the Ramrod, leaving a second set of priming bar slots if you have screws sear off in the first set. Just turn over the rambase and use the other slots.