Silverstone SG13 Side Mount I/O

PORT SPACING SKETCH INDLUDED

An SFF board I had was just barely too long for the SG13, so I cut the lip down in the front and had to remove the front ports. Decided to mount it to the side of the case and it worked out. The io board bows up a little because nothing is securing it down besides the snug fit of the part I printed. Need to design a little clip to go on the inside. Also, this is my first go at modeling so please be nice lol. Feedback is appreciated.

Steps:
1. remove front panel, electronics (light, buttons, io), dust filter, and metal mesh
2. cut away plastic to fit the io board (I used side snips, coping saw, and file)
3. check fit of part in the hole (use sandpaper and a file to adjust it)
4. glue in place with epoxy resin
5. sand, clean, and paint