Sim Racing Handbrake

Hello,

This is a project I did to create a Sim-Racing Handbrake. I made these from mostly 3D printed parts, all of which are attached to this thing page.

Please see my video for an explanation on how it was designed, and how the electrics are wired up!

The following HW was used in addition to the 3D printed components:

1. 5/16-24 x 2" SH Bolt, Qty 2
2. 5/16-24 x .75" SH Bolt, Qty 4
3. 5/16-24 Nut, Qty 6
4. Skateboard Bearings, Qty 6, 22mm diameter, 7mm thick
5. 10kΩ Potentiometer, Qty 1, 270 degree range
6. 10kΩ Resistor, Qty 1
7. Arduino Micro, Qty 1
8. Solder
9. Wire
10. Super Glue
11. Rubber Bands
12. #6 x 1" All purpose Screws, Qty 4

All code that I used is located here: https://github.com/b5050d/CodeShare

The Arduino Library that I used can be found here:
https://github.com/MHeironimus/ArduinoJoystickLibrary

I hope you enjoy this thing and can learn or utilize something from it.

Please see my YT channel here:
https://www.youtube.com/@Fifty50-En