Thingiverse
Sim Racing Pedals
door b5050d
190
Downloads
306
Likes
3
Makes
Hello,
***** DISCLAIMER START
This design is provided for personal and experimental use only.
It is supplied “as-is”, without warranty of any kind, express or implied, including fitness for any particular purpose or safety.
By downloading or using this file, you accept all risks associated with printing, manufacturing, or using the design. The author assumes no liability for damages, injury, or loss resulting from its use.
***** DISCLAIMER END
This is a project I did to create some Sim-Racing pedals. I made these from mostly 3D printed parts, all of which are attached to this thing page.
Please see my video for an explanation on how it was designed, and how the electrics are wired up!
The following HW was used in addition to the 3D printed components (List quantities are per each pedal, with the exception of the Arduino):
1. M2x14 SH Bolt, Qty 6, Used to fix the pedal head to the pedal spacer
2. M2 Nut, Qty 6
3. Compression Springs, Qty 1, ~60mm x 20mm with ~30mm compression, I
***** DISCLAIMER START
This design is provided for personal and experimental use only.
It is supplied “as-is”, without warranty of any kind, express or implied, including fitness for any particular purpose or safety.
By downloading or using this file, you accept all risks associated with printing, manufacturing, or using the design. The author assumes no liability for damages, injury, or loss resulting from its use.
***** DISCLAIMER END
This is a project I did to create some Sim-Racing pedals. I made these from mostly 3D printed parts, all of which are attached to this thing page.
Please see my video for an explanation on how it was designed, and how the electrics are wired up!
The following HW was used in addition to the 3D printed components (List quantities are per each pedal, with the exception of the Arduino):
1. M2x14 SH Bolt, Qty 6, Used to fix the pedal head to the pedal spacer
2. M2 Nut, Qty 6
3. Compression Springs, Qty 1, ~60mm x 20mm with ~30mm compression, I
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
