Thingiverse
Sim Steering wheel spacer
di hooten
48
Download
25
Likes
1
Makes
This is for attaching a diy wheel to a QR hub. I printed it with 75% infill and have been using it on a direct drive wheelbase with no problems so far. It's set up for a 70mm PCD and will fit an M5 bolt.
You will have to rotate the hub in your blender software so the supports are easy to remove.
I've been using this for over 2 months in a direct drive with no problems (clipping a little and hitting the estop after big hits)
Feel free to leave a tip no matter how small if you liked this design.
You will have to rotate the hub in your blender software so the supports are easy to remove.
I've been using this for over 2 months in a direct drive with no problems (clipping a little and hitting the estop after big hits)
Feel free to leave a tip no matter how small if you liked this design.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
