Simjack UT Die Spring Spacers

Modded AucoinTech_3409228's Simjack pro design to fit the Simjack UT's. The shaft on my UT's was 9mm instead of the 10mm in aucointechs design. The hole on the base plate was also wider than the simjack pro so I made the baseplate connector fit better too. 3 different files, print whatever combo you want. Note the shaft ones won't fit where the thread starts so use the thread labelled file. I printed in PETG but I'm sure PLA would be fine. I'm using a 30mm yellow and a 70mm red die spring. It gives a bit more travel than the standard elastomers. Boost Me