Thingiverse
SimLab P1X simrig windsim duct mount
von joaoc
3
Downloads
4
Likes
0
Makes
Designed this mount to install a cold air intake duct on the side of a SimLab P1x rig.
The holes in the mount give some room for adjusting the vertical angle.
PLA at 45% infill it is quite strong, with no noticeable flex, even with some tension from the duct.
The holes in the mount give some room for adjusting the vertical angle.
PLA at 45% infill it is quite strong, with no noticeable flex, even with some tension from the duct.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
