Simple badge holder

###[**New and improved version available here**](https://www.thingiverse.com/thing:3654880)

Just a simple badge holder, nothing more than a smooth edge around your badge. Cards easily slide in from either side and are tightly snapped in place. Model needs supports to print the overhangs that keep the badge in place.

**Sept. 2, 2018** - Initial upload of PVA and Durable model
**Sept. 25, 2018** - Added two-part model for dual color printing

### badge_PVA.stl

> This model contains a long, smooth overhang that is best printed with PVA support material, but also doable with PLA as long as you don't mind sanding and finishing afterwards.

### badge_durable.stl

> This model contains multiple short overhangs which require minimal PLA support. I recommend using high-density support with increased horizontal expansion. With 70% infill and 2mm horizontal expension, you get solid support blocks which easily snap away without damaging the bottom layer.

### badge_twopart_top.st