Thingiverse
Simple Bookend
by deschnell
209
Downloads
147
Likes
2
Makes
A very simple bookend - printing as I type this (ABS).
I tend to print with objets at -0.07 (z) to prevent the need for a raft - so far has worked well. I'm using helper discs on the corners of this to prevent warping since it's a thin flat section prone to such.
Trying with low settings (0.3mm height, 80mm/s speed, 10% infill with 3 shells).
Update - printed out now, and working good - see pictures. I did sand down the sharp corners... perhaps a mod could be to fillet the corners off.
I tend to print with objets at -0.07 (z) to prevent the need for a raft - so far has worked well. I'm using helper discs on the corners of this to prevent warping since it's a thin flat section prone to such.
Trying with low settings (0.3mm height, 80mm/s speed, 10% infill with 3 shells).
Update - printed out now, and working good - see pictures. I did sand down the sharp corners... perhaps a mod could be to fillet the corners off.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
