Thingiverse
simple box with lid
door smintarz
13
Downloads
32
Likes
0
Makes
Update: I've added an additional no-support version for the lid that comes without the overhang edge and is a lot thinner, so it prints also faster.
I've also added a one-compartment version of the box.
----
A simple bigger box with two compartments and a lid for storing things.
The box is 220x132cm and has a total height of 134cm and 108cm without the knob.
Each compartment is 100x116cm with a height of 98cm from bottom to the lid.
The box is support free, but the lid need a little support for the overhang edge.
Printed my box in Geeetech Matte Olive Green PLA in 0.2mm and it took around 8 hours with 10% infill. The lid was Geeetech Matte Black PLA, also 0.2mm with line supports and took around 3.5 hours.
I've also added a one-compartment version of the box.
----
A simple bigger box with two compartments and a lid for storing things.
The box is 220x132cm and has a total height of 134cm and 108cm without the knob.
Each compartment is 100x116cm with a height of 98cm from bottom to the lid.
The box is support free, but the lid need a little support for the overhang edge.
Printed my box in Geeetech Matte Olive Green PLA in 0.2mm and it took around 8 hours with 10% infill. The lid was Geeetech Matte Black PLA, also 0.2mm with line supports and took around 3.5 hours.
smintarz publiceert ook op
33 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
