Thingiverse
Simple Calibration & Centring Print
par SmithRC
22
Téléchargements
8
Likes
0
Makes
A simple calibration & centring print
as the text on the print says - its 100mm x 100mm x 5mm (XYZ)
It also includes a centre 'target' so you can measure the print position and adjust your bed accordingly.
Print it, Measure the actual dimensions and calculate the steps needed in your firmware to make the dimensions correct.
Re-print and re test a few times and average the results if needed.
as the text on the print says - its 100mm x 100mm x 5mm (XYZ)
It also includes a centre 'target' so you can measure the print position and adjust your bed accordingly.
Print it, Measure the actual dimensions and calculate the steps needed in your firmware to make the dimensions correct.
Re-print and re test a few times and average the results if needed.
SmithRC publie également sur
2 modèles supplémentaires sur 1 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
