Thingiverse
Simple CNC clamps
von BarcaLS
14
Downloads
15
Likes
0
Makes
Just a few simple clamps for your CNC.
I did it for my Snapmaker Artisan because it is:
1) useful when working on small pieces
2) cheap and harmless for your CNC bit in case of exceeding boundaries.
Hole is 5mm width so works with standard M4 screws from original clamps from Snapmaker.
I did it for my Snapmaker Artisan because it is:
1) useful when working on small pieces
2) cheap and harmless for your CNC bit in case of exceeding boundaries.
Hole is 5mm width so works with standard M4 screws from original clamps from Snapmaker.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
