Thingiverse
Simple Cone Lampshade
door carbon8
24
Downloads
29
Likes
1
Makes
A simple cone lampshade with a rounded edge for your run-of-the-mill five-armed bendy lamp.
My settings:
vase mode
0.8mm nozzle, 1.3mm width
0.64mm layer height
5 solid bottom layers (the hole cut in the bottom for the lamp to screw to is 3.2mm into the model, so any amount of layers that stays at/under 3.2mm in combined height should work)
My settings:
vase mode
0.8mm nozzle, 1.3mm width
0.64mm layer height
5 solid bottom layers (the hole cut in the bottom for the lamp to screw to is 3.2mm into the model, so any amount of layers that stays at/under 3.2mm in combined height should work)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
