Simple corn on the cob holders
von IRLprops
4
Downloads
2
Likes
0
Makes
Simple corn on the cob holder.
Requires 2 20/25mm Stainless steel panel pins
Print at 100% or larger (if you're using larger panel pins/nails)
Depending on tolerances pressure fit or a small amount of glue in the cup section to secure everything
Requires 2 20/25mm Stainless steel panel pins
Print at 100% or larger (if you're using larger panel pins/nails)
Depending on tolerances pressure fit or a small amount of glue in the cup section to secure everything
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
