Slicer Discord
Simple Couchfoot-Extension – 3D-Druckmodell von Thingiverse Thingiverse

Simple Couchfoot-Extension

von AWeleczka
6 Downloads
5 Likes
2 Makes
Zum Modell
This Thing was made for the IKEA couch in my living room so your mileage, with your couch, may vary.
This is a simple 2 cm (25/32 in) extension to the foot of a couch - in my case needed so my vacuum-robot could pass under it easily.

This Thing comes in two flavors: Just the foot and a foot with a built-in wall-spacer of around 20 cm since my couch kept sliding right against the wall all the time (better for air-circulation behind it ;) )

The foot measures 52 mm (2.04724 in) on the inner diameter and 60 mm (2.3622 in) on the outer diameter.
The lift is 20 mm (0.787402 in) with a total height of 30 mm (1.1811 in)
* * *
You can also find the original model on the [Fusion 360 Hub](https://a360.co/2Rge8UX)
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

5 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen