Thingiverse
simple customizable bearing spool holder
von Aledt
15
Downloads
9
Likes
0
Makes
simple spool holder to run on bearings on a threaded rod.
Print two of these, drop the bearings in, one goes each side of the spool with a threaded rod through the middle of the lot and tighten up with wingnuts either side.
designed for skate bearings (608) on an m8 threaded rod for a spool with 35mm center bore but can be customized to fit other size spools or different bearings etc.
Print two of these, drop the bearings in, one goes each side of the spool with a threaded rod through the middle of the lot and tighten up with wingnuts either side.
designed for skate bearings (608) on an m8 threaded rod for a spool with 35mm center bore but can be customized to fit other size spools or different bearings etc.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
