Thingiverse
Simple customize air assist nozzle
von Kushnirenko
2
Downloads
5
Likes
0
Makes
Customize air assist nozzle
Default setting for AlgoLaser ALM-5BD(5W)
How to use:
-------------
* Customize parameters & print nozzle
* Check - the nozzle should fit with a little effort. If necessary, treat the seat.
* Cut the end of the tube at an angle - as shown in the photo.
* Insert the tube into the hole and fix it with hot glue
Default setting for AlgoLaser ALM-5BD(5W)
How to use:
-------------
* Customize parameters & print nozzle
* Check - the nozzle should fit with a little effort. If necessary, treat the seat.
* Cut the end of the tube at an angle - as shown in the photo.
* Insert the tube into the hole and fix it with hot glue
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!