Simple Desk Shelf Legs

Some simple legs for a desk shelf. I made these legs for a piece of reclaimed scaffolding with width 14.5mm. And the holes for screws are countersunk M3 (ie. 3.4mm hole size) If you are scaling this for a shelf with different dimensions, remember to check the screw sizes you will need. —————————————— This was prototyped in standard PLA. The printer I used to prototype this was a Bambu P1S with the following settings (if you also have this printer then there is a 3MF already attached. I used the following settings Layer height: 0.2mmInitial layer height: 0.2mmInfill: 15% GridWall loops: 3 Supports: No