Thingiverse
Simple diffuser for 50 mm LED spot
by DrLex
33
Downloads
21
Likes
0
Makes
This is a simple dome-shaped diffuser for a common type of LED spot with 3 LEDs and a 50 mm outside diameter. It comes in a smooth and low-poly version. The latter may be somewhat easier to print. Supports should not be necessary, but you will definitely need adequate cooling to print the large internal bridges and steep overhangs. A brim may also be a good idea, although it should not be necessary with good adhesion.
If it is too tight or loose, scale it up or down by a few fractions of a percent.
If it is too tight or loose, scale it up or down by a few fractions of a percent.
DrLex also publishes on
29 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
