Simple Door Knob for Plexiglas

USE FUZZY SKIN Simple Door Knob for Plexiglas I made this small door knob for a Plexiglas door. It’s easy to print and works well. Nothing fancy – just useful. I used an M3 heat insert in the back of the knob. Then I put an M3 screw through the Plexiglas and into the insert. Make sure to use the right screw length for your Plexiglas. A washer is also a good idea to protect the surface. 🧰 Materials: 1x M3 heat insert 1x M3 screw (length depends on your Plexiglas) 1x M3 washer (optional, but recommended) PLA or PETG filament 🖨️ Print settings: Layer height: 0.2 mm Infill: 20% No supports needed Let me know if you print it or improve it!