Thingiverse
Simple feet for a box
door Wirecase
87
Downloads
45
Likes
1
Makes
I needed some simple feet/standoffs for my CaseRap printer case so in transport mode it would not sit directly on the wooden surface and on/off switch. This is my simplest design to date, haha.
The feet will take a 3.5 mm wood screw. The head of the screw will sink nicely into the opening of the feet so not to scratch up any surface you put the case/box on.
The feet will take a 3.5 mm wood screw. The head of the screw will sink nicely into the opening of the feet so not to scratch up any surface you put the case/box on.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!