Thingiverse
Simple fidget spinner
door DevDorian
13
Downloads
6
Likes
0
Makes
Another fidget spinner of this same generic design that you see everywhere. Was bored. Wanted to make something quick and easy in Fusion 360.
Requires 4x 608 Skate Bearings, printing the body and 2x of the caps. Press fit the 608 bearings into the body, the caps on either side of the center bearing and voila!
Bearing holes and cap pegs use a 0.01mm press fit tolerance. Should be good for most 3d printers.
Requires 4x 608 Skate Bearings, printing the body and 2x of the caps. Press fit the 608 bearings into the body, the caps on either side of the center bearing and voila!
Bearing holes and cap pegs use a 0.01mm press fit tolerance. Should be good for most 3d printers.
DevDorian publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
