Simple Filament Spool Holder

YES a other Filament Spooln Holder ;-)


For this is required.

3D printed parts:

2 x filament spool holder frame (Rahmen *)

wide version
2 x Filamentrollenhalter halbe Welle A 104 (wide version for up to 104mm spool width)
2 x Filamentrollenhalter halbe Welle B 104 ((wide version for up to 104mm spool width)

or narrow version
2 x Filamentrollenhalter halbe Welle A 82 (narrower version for up to 82mm spool width)
2 x Filamentrollenhalter halbe Welle A 82 (slighter version for up to 82mm spool width)

standard parts:
4 x ball bearings 688ZZ (8x16x5)
4 x washers for M8 ("fender washers" have a larger contact surface)
4 x M8 acorn nut
2 x M8 threaded rods cut to length

Assembly:
put two filament roll holders half shaft A & B together (wide or narrow version) and press in a ball bearing at each end.

Cut 2x threaded rods and put them through a filament roll holder frame (flat side outwards)
attach washers and cap nu