Thingiverse
Simple Go, No-Go Calibration Tool
von mrjohn
8
Downloads
11
Likes
1
Makes
UPDATE 12/29/2011 2:42PM- Deleted old .stl, it was bad, added correct file.
These two test pieces are printed with one on the X and one on the Y axis. The idea is that they should both fit each other. Use when your circles come out oval.
If the X and Y are not calibrated well this test will show you which is off.
These two test pieces are printed with one on the X and one on the Y axis. The idea is that they should both fit each other. Use when your circles come out oval.
If the X and Y are not calibrated well this test will show you which is off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
