Thingiverse
Simple headphone holder
von Snuggery
0
Downloads
0
Likes
0
Makes
Simple headset holder for mounting on a edge (see pictures)
U can use screws but i used double sided tape
Infill: 20-100% (i used 20%)
supports: Yes 45° (U can print without supports only adds 4 Min)
Thank you!
U can use screws but i used double sided tape
Infill: 20-100% (i used 20%)
supports: Yes 45° (U can print without supports only adds 4 Min)
Thank you!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
