Thingiverse
Simple Light House
by gwhancock
20
Downloads
20
Likes
1
Makes
Test model for a hollow simple light house.
Not to scale or relative to any existing Light Houses, just prepared for fun.
original height (assembled) = 7.1 + inches , the STL file is pre-cut to allow printing on the Makerbot Replicator 2.
If you place the roof inside the lighthouse you can reduce the footprint on the build plate (Individual STL files not provided currently)
Full scale the side walls are about 1/8 inch (3mm thick) and all over hangs and steps are designed to be printed without support structure.
==================================================
5h42 min (25 mins for raft, not required)
10% infill
2 layer
0.3mm
Replicator 2
Not to scale or relative to any existing Light Houses, just prepared for fun.
original height (assembled) = 7.1 + inches , the STL file is pre-cut to allow printing on the Makerbot Replicator 2.
If you place the roof inside the lighthouse you can reduce the footprint on the build plate (Individual STL files not provided currently)
Full scale the side walls are about 1/8 inch (3mm thick) and all over hangs and steps are designed to be printed without support structure.
==================================================
5h42 min (25 mins for raft, not required)
10% infill
2 layer
0.3mm
Replicator 2
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!