Thingiverse
Simple Lightsaber Wall Mount
von pirsquar
47
Downloads
37
Likes
0
Makes
A pair of simple clips to hold Leia's Lightsaber horizontally on the wall.
The small clip is for the 'neck' and the large is for the 'pommel'. If you print them in the same copper as the saber parts, they'll barely be noticeable.
They can be printed as-is, but they'll be stronger if rotated 90 degrees, so that the curved part of the clip is parallel to the bed (as shown in the Cura screenshot)
The small clip is for the 'neck' and the large is for the 'pommel'. If you print them in the same copper as the saber parts, they'll barely be noticeable.
They can be printed as-is, but they'll be stronger if rotated 90 degrees, so that the curved part of the clip is parallel to the bed (as shown in the Cura screenshot)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!