Thingiverse
Simple Lithophane Stands
door JackCrescent
14
Downloads
5
Likes
0
Makes
These are essentially simple lithophane stands, they are ready to print as-is, and hold the lithophanes securely, maybe not as tight as an exact fit, but due to the tolerances of my printer, I chose something that could be a bit more universal.
The stand with the two holders is made for rectangular or square lithophanes (yellow in the 3d printed model)
The smaller stand with only one holder is better suited for curved lithophanes, if the curve is too aggressive it might not be able to be accommodated.
You may notice that the yellowish stand holder is a bit close to the circle for the candle, this was fixed in the model that is released. This was the first draft of the stand, so no worries in the STL you are receiving it should be fine.
As you may have also noticed in the pictures, the space in front of the lithophane allows you to put small decorations. This can be done in your slicer very easily, allowing you to put personal touches with ease.
In the case of the yellow
The stand with the two holders is made for rectangular or square lithophanes (yellow in the 3d printed model)
The smaller stand with only one holder is better suited for curved lithophanes, if the curve is too aggressive it might not be able to be accommodated.
You may notice that the yellowish stand holder is a bit close to the circle for the candle, this was fixed in the model that is released. This was the first draft of the stand, so no worries in the STL you are receiving it should be fine.
As you may have also noticed in the pictures, the space in front of the lithophane allows you to put small decorations. This can be done in your slicer very easily, allowing you to put personal touches with ease.
In the case of the yellow
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
