Simple parametric remote control holder maker - sky q remote as example
door fatdavemakes
3
Downloads
1
Likes
0
Makes
Simple openscad file for creating holders for remote controls.
The openscad file has two different sized remotes created and next to each other as an example. You can use this to make a single remote.
The file is commented for the parameters and is very simple.
I have stuck these on the wall rather than screwing, unless your remotes a very heavy then you should have limited issue but wings and screw holes could be added easily enough(if anyone wants this but doesn't know how just drop me a comment and I'll update to include as an option).
Printed at 0.3mm layer heights, 2 perimeters and 100% infill.
The openscad file has two different sized remotes created and next to each other as an example. You can use this to make a single remote.
The file is commented for the parameters and is very simple.
I have stuck these on the wall rather than screwing, unless your remotes a very heavy then you should have limited issue but wings and screw holes could be added easily enough(if anyone wants this but doesn't know how just drop me a comment and I'll update to include as an option).
Printed at 0.3mm layer heights, 2 perimeters and 100% infill.
fatdavemakes publiceert ook op
32 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
