Simple Pi Camera Mount

I wanted a mounting solution for a RPi camera inside my printer but was satisfied with none of the ones I found. So I spent a few hours in Fusion 360 and put this out.

I tried to make it fairly generic, since my printer is a v1 Anycubic 4Max Pro. The slot in the base is 2.5mm to fit onto the back of the frame near the Z-axis lead screw, but I also made the base wide enough so one could just use mounting tape on either side of the swivel joint as a solution as well.

Note on size: the case is specced for an old-style RPi camera (v1.3) since that's what I had on-hand.

**BOM:**

1x RPi camera v1.3
1x 16mm W flex cable (FFC) (I used 1m length, because I am excessive)
4x M2x10 screws (for mounting the camera; the case is a tight snap-fit, so it's not entirely necessary)
2x M3x16 screws
2x M3 nuts