Simple Purge Line Brush

A simple brush made using Purge Line waste.No hardware or glue required.Uses the “L” ends to create the bung. The ends have been “painted” in studio, but this only requires one filament change when printing, or just print in one colour. To Assemble:Trim the “dot” end of the purge lines off.Feed them through the hole so the the “L” shape of the lines all bunch together.Bend the L's over a bit.Slide it together.Trim the lines to desired length.Use your new brush to sweep up the mess you just made!Not as efficient as some designs where you fold the lines over to maximise line : bristle ratio, but you could try bending the purge lines in half and using some tape or something to create the inside “bung”.