Simple Razor and Brush Holder

I needed a proper way to store my razor and shaving brush, and this is my solution! I was inspired by some of the other razor and brush holders on MakerWorld, but none of them fit inside my bathroom vanity, which only has about 125mm between shelves. My razor handle is also quite long, which makes packaging everything a little tricky. I also wanted a stand that could print without support, and allowed front access to the razor and brush. I sloped the bottom surface so any water would run towards the front of the stand. I printed this using Elegoo rapid PETG but I'm sure PLA would be fine as well. The slot for the razor is 11mm wide, and the slot for the brush is 30mm wide.