Simple Skadis panel connectors

Simple Skadis panel connectorsI made my Skadis pegboard panel for my IKEA VITTSJÖ shelf using this (https://makerworld.com/en/models/485806#profileId-398399) parameterized model, I really like it.However, I could not find any connectors fits this panel in “fewer screw mode” is NOT enabled. Simillar connectors do not match the bolt spacing (they are 20mm pitch.) The above panel has “16mm” pitch. So I decide to make original connectors. In addition, my Skadis panel is skeletonized, back side of panel is visible, I want my connectors to simple appearance.So I design them to fit the corner round of the panel. It looks good.I printed with TINMORRY PETG-ECO filament, please use whatever you like. The kit contains which parts for connect 4 panels.1x central connector4x side connector4x corner nut *this is optional I didn' t like that screw holes in corners were left open, so I make “corner nut” for decoration. These are optional parts.*note the corner nut's screw hole is very hard to