SIMPLE SNAP-TOGETHER RAMPS CASE | HYPERCUBE

This is my Hypercube Ramps Case. It is a snap together design so that you can quickly open and close it without any screws.
All the parts are easy to print without support structures. I cut 2 threads in the 2mm holes in the mounting plate to screw the ramps mounting screws directly into the plastic. You can also use longer M3 screws (M3x25) and lock them with two M3 nuts.
I also used 5mm high plastic spacers between the mounting plate and the arduino board.
But you can also print the spacers from the download files ("stand_off_pcb.stl")
On the right side I have a cheap 7mm push button (normally open) which i soldered to the reset button on my ramps board.
If you have difficulties at the beginning with the snap-together parts you can use a little bit of grease on all the plastic noses. This helps quite a lot.

PARTS THAT YOU MIGHT NEED:

Mounting brackets
- 2x M4x8mm Countersunk Screws (mounting brackets)
- 2x M4 Nuts
- 2x T-Slot Nuts
- 2x M5 Screws for the T Slot Nuts