MakerWorld
Music
Zum Modell
Simple strong mic support for Audeze
13
Downloads
3
Likes
10
Makes
I made this model after trying another one online and finding it too fiddly and well, kinda fugly. This one prints fast, looks great and works well, with good rigidity despite it's minimalist approach. The problem with these great Audeze (Maxwell in my case) headies is the ‘boom’ mic is just too soft, so to speak. (yeah, like that…) So you're always moving it back up into position, and it gets more floppy over time with more movement. This little guy clicks onto the mic shaft tightly enough to hold the head right where you want it! You can rotate it a bit closer or farther from your mouth if you want, and it will never sag. The remainder of the shaft is short and stiff enough to hold itself up without support, even with the cover on. Pictured is Bambu PLA Basic Blue with Bambu PLA Basic Jade White IIRC, I did the first one on textured PEI which looks great too, but this one was on the smooth plate so you can see interesting details. I used Classic but you might try Arachne, or
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!